The Edge-Pro is a totally new design and there is virtually no setup required. Your operator can reinforce sheets of various lengths and widths with minimal effort. The Edge-Pro adjusts to any weight paper from 6-point to 17-point. The Scott Edge-Pro automatically senses the edge of the sheet to cut tape flush top and bottom — even when sizes are intermixed. Installing the tape reel is the only setup required — and it takes less than three minutes to thread the machine. Handles Variety of Sheet Widths, Lengths and Weights Applies almost any film up to 3/4 inch (19.1 mm) wide. The Edge-Pro handles sheets 3-1/2 inches wide to 17 inches wide (88.9 mm to 431.8 mm). It reinforces sheets from 8 inches (203 mm) long to any length. Edges shorter than 8 inches can be run in multiples and cut apart later. Sheets wider than 17 inches can be accommodated by adding support beyond the table top to prevent overhang. Safe Operation All plastic cutting is done within the machine head, protecting the operator from injury. Proven Durability The compact aluminum plated body serves as a solid base for this high production piece of equipment. Proven to stand the test of high-volume jobs, the Reinforcer requires minimal maintenance to keep it operating smoothly for years. *Available with Optional Automatic Feeder Although this machine is fast and easy to hand operate, you can increase your production rate by up to 50% with an optional automatic feeder.  Once installed, this feeder allows the operator to load and unload the delivery tray without stopping the machine. This can increase the output up to 4,500 reinforced sheets per hour.

*(Please note old style feeders will not fit on the Edge-Pro and configurations may vary depending specific customer requirements.)